Amida makes some of the very best interior pieces I've ever seen, it looks factory good, and makes them available here. Check out "Rob's Interiors" thread.  The down side is that because of the high quality, it aint anything near cheap, making it too much of a stretch for some kit's budgets.  I'm sure there are some here that would be willing to skimp a little on the accuracy and maybe quality too, for an interior they could better afford.  You got any pics? 

Italiandesignes

Do you have the rear valance under the rear bumper on the 328? The part that covers the exhaust system etc. under the bumper is what I am talking about.  I have a full set of molds I bought for a 328 kit but I did not receive the mold for the rear valance piece.  I was going to make a buck and then mold from there but if there is one already available, that would be much easier.

Also, I am looking to sell off the molds as well since I don't seem to be doing anything with them at all.

Cheers
Don